Repeaters and solar
A repeater is just a regular node placed up high and left running. A few well-placed ones are what turn scattered radios into a county-wide network.
Have high ground? We'd love to talk.
A ridge, a hilltop, a tall barn, a silo, a church steeple or a tower can link two valleys that could never hear each other otherwise. A solar repeater is a weatherproof box about the size of a paperback. It needs no wiring and no internet. Get in touch if you might host one.
Where to put one
- Height and a clear view matter most. They beat any antenna or radio upgrade.
- Walk the area first with a handheld node and note where messages stop. Put the repeater where it fills the gap.
- Space them out. Two repeaters covering the same ground add traffic, not coverage.
Power
- Use an nRF52 board for anything on solar. It uses a small fraction of the power of the cheaper ESP32 boards.
- Always put a battery between the panel and the node. A panel alone goes dark at dusk.
- A small panel of a few watts and one lithium cell will run a low-power node year-round if the panel faces south with no shade.
- Size the battery to last about five days without sun.
Ohio winters
- Lithium batteries should not be charged below freezing.
- December sun delivers roughly a third of what July does. Tilt the panel steeply and keep snow off it.
- Check a new repeater after the first hard freeze and the first heavy rain.
Weatherproofing
- A sealed box with the cable entry facing down.
- Self-fusing tape on outdoor antenna connections.
- A small desiccant pack inside. Trapped moisture ruins more nodes than rain.
Settings for a repeater
Use CLIENT_BASE for your own pole or roof node, and mark your handheld nodes as favorites on it. Shared hilltop repeaters get their role assigned by the group. See settings.
Permission
Always get the owner's permission before putting a node on any property that isn't yours, and keep a note of who agreed and when.