Hardware guide
Start cheap. A $20 board teaches you everything, and nothing here is wasted if you upgrade later. Always buy the 915 MHz (US) version.
What to buy
| If you want… | Get this | About | Notes |
|---|---|---|---|
| The cheapest way to start | Heltec WiFi LoRa 32 V4 | $18–20 bare, $30–40 with case and battery | Small screen. Charge it like a phone. |
| A handheld with long battery life | Heltec Mesh Node T114 | $35–45 | Very low power. |
| A solar or battery repeater you build | RAK WisBlock Meshtastic Starter Kit | $31–35 | The standard low-power repeater board. Needs a battery, antenna and box. |
| A solar repeater ready out of the box | RAK WisMesh Repeater Mini | $99 | Sealed, with battery and solar panel built in. |
Prices are approximate and change often.
Two kinds of boards
- ESP32 boards (like the Heltec V4) are the cheapest, but use more power. Fine for a node you carry and recharge, or one that stays plugged in.
- nRF52 boards (like the RAK and the T114) sip power. Choose these for anything running on solar or a battery you rarely check.
Antennas
- The little antenna in the box works for getting started.
- For a fixed node outdoors, a 915 MHz fiberglass antenna around 3 dBi is the right first choice for our hills. It spreads the signal up and down slopes.
- Taller "high-gain" antennas reach farther over flat ground but can shoot right over a valley.
- Be skeptical of small antennas claiming big numbers. A six-inch whip is not 10 dBi, whatever the listing says.
- TV, CB and Wi-Fi antennas will not work.
Also budget for
- A lithium battery, if your kit doesn't include one. Check the red and black wires match the + and − marks on the board before plugging in.
- A case, or a weatherproof box for outdoor nodes.
- A USB cable that carries data, not just power.
Where to buy
- Rokland, a US distributor for RAK and Heltec
- Heltec
- RAKwireless
- Amazon carries most of these too. Check that the listing says 915 MHz.
Last reviewed: November 2026